Dual Supply +5 and -5 using 555
In this circuit the 12 DC, two wire is converted to three wire +5 and 0 and -5 dual supply useful for op-amps or other interface circuits. You could use 7805 and 7905 low...
Linearizing Circuit with Opamps
The thermocouples and some other sensors have an output that is non-linear. That means the mV generated by them are not in direct proportion to the parameter measured. In signal conditioning Linearization can be...
Generic LM317 Switching Supply
This was a common way LM317 was used to get a stable power for small devices. It is still useful for learning and some blocks of the circuit are still used today in modern...
Fluid or Water Level Indicator
The Reed Relay based Float Switches are used in Automobiles and even corrosive and volatile fluids. This can also be used to indicate level of water or operate pumps. The reeds are hermetically sealed...
80C39 and MCS48 based Process Controller
The Early Microcontroller : 80C39 is a CMOS Version of 8048 the one that preceded 8031-8051. MCS48 is the set for that, MCS51 is the current set. Digital to Analog Converter with uC Watchdog...
Telephone status indicator with LED
This will monitor telephone status without loading the telephone line, this way if you have two phones in parallel you will know if one of them is busy. Connect the two ends of circuit...
Button and four LED Lights
Need a design – Simple one button push button to turn on 4 different LED (3mm Dome) every time you press the button. 555 Circuits, LED Schematic. User Interface Design. JE USA Attached is...
+5 to -5 using a 555 Astable Multivibrator
This is a very simple -5V supply using one 555, useful for analog blocks using FET Opamps using low power. This circuit came up when i had to design limited by inventory. It worked...
