Mini RTD Pt100 Three Wire Transmitter
These are the circuits and boards of a Mini Temperature Transmitter for a Platinum hundred ohms temperature Sensor. Has a 4-20mA sink output. Current Loop can be used for multiple instruments.
These are the circuits and boards of a Mini Temperature Transmitter for a Platinum hundred ohms temperature Sensor. Has a 4-20mA sink output. Current Loop can be used for multiple instruments.
I don’t remember if this circuit worked properly. But a few were made and i might not have shown the modifications that were done to make it work. This was meant to be a...
Neon Light Flasher was made by me when i was young, it was even published in a magazine, i think it will work, it was used on a very old huge ornamental valve philips...
This LED Indicator uses a LM339, a quad comparator. LM339 can work on single or dual supplies, it has a open collector output that can drive 15mA, low power consumption. The circuit is an...
This is a AC Control Input AC Output SSR Solid State Relay. When a Process Controller has an AC output or a system generates an AC signal of above 100V AC to signal the...
This circuit gives a burst of pulses to fire 2 SCRs, when pin 4 is taken to 12V the SCR is turned on, to use this circuit you need 12V short pulses phase shifted...
This is a very simple -5V supply using one 555, useful for analog blocks using FET Opamps using low power. This circuit came up when i had to design limited by inventory. It worked...
Thermocouple is the most common sensor in Industrial Temperature Measurement. The Signal Conditioning involves Cold Junction Compensation and High Gain DC Amplification. The output of a Themocouple is in millivolts.