AC-AC SSR Solid State Relay
This is a AC Control Input AC Output SSR Solid State Relay. When a Process Controller has an AC output or a system generates an AC signal of above 100V AC to signal the load to turn on, this device can be used. A BTA40-600 and MOC3041 are used in this.
A high voltage plastic cap limits current to a bridge which generates a small DC from 230 V AC, this drives MOC3041. The rest is the same. It is better to use a DC control SSR where possible. This AC control SSR is used where only an AC control signal is available. The BTA series has the heatsink tab insulated from the Triac chip inside. The BTB needs electrical insulation to the heatsink.
Electrical Control Panel Wiring
These devices BTA40600 and MOC3041 make SSR’s very simple. They have proved very reliable and rugged in the field, overrate your designs, use heat sinks and seal the SSR with thermally conductive epoxy. Alumina with ciba araldite without any other filler or dye is the best way to hermitically seal.
